Review Comparing Behr Solid Weatherproof Deck Stain to Its Premium Product
BEHR PREMIUM® Solid Color Waterproofing Stain & Sealer
Protect and adorn with BEHR PREMIUM Solid Color Weatherproofing All-In-Ane Wood Stain & Sealer. This 100% acrylic formula seals out the elements, and the sunday'southward harmful UV rays, for up to 10 yrs. on decks and upwardly to 25 yrs. on fences and siding. Information technology'due south bachelor in more than 1,600 custom colours to assistance y'all get just virtually whatsoever expect you lot can imagine.
See Our Selection of Solid Colours.
Finish
Creates a Solid Colour picture that hides wood imperfections while allowing wood texture to evidence through.
All-time for use in
Properly prepared new to heavily weathered or great forest surfaces (0 to 15+ years exposure).
Coverage
1st Coat nineteen-37 m2 ; 2nd Coat 37-74 chiliad2
0
Recommended for properly prepared new to heavily weathered or cracking wood surfaces (0 to 15+ years exposure) such as: Decks, Railings, Shakes, Shingles, Siding, Roofs, Fences, Forest Patio Furniture and Composites.
Read More than
The post-obit steps are recommended for best results.
- Use a product such as BEHR PREMIUM® NO. 64 Wood Stain & Finish Stripper to remove loose wood fibers, latex, oil-based and 100% acrylic coatings on new or weathered wood. BEHR PREMIUM® NO. 63 All-In-Ane Wood Cleaner MUST be used following NO. 64 to clean, brighten & neutralize wood.
- When NO. 64 is not needed, use a product such as NO. 63 to clean and brighten the wood surface and to remove light to medium exterior stains caused by mold, mildew, algae & fungus. Rinse thoroughly and allow to dry out before coating.
- On new woods, use a production such as NO. 63 to remove mill glaze and open the pores of the wood. Lightly sand to remove remaining woods fibers/fuzz.
Read More
- Must apply between 5-32˚C.
- Practise non employ if rain is expected inside 24 hours. The wood surface must exist completely dry out earlier application.
- No primer needed on most wood. However, Redwood, Cedar, Cypress, and other "bleeding" wood incorporate water-soluble extractives which may cause discolouration of white and pastel colours; therefore prime the to a higher place type forest with one glaze of a product such every bit BEHR® NO. 436 Outside Multi-Surface Primer & Sealer. Meet the label for additional instructions. Intermix multiple containers to ensure color uniformity.
- Stir product occasionally throughout the awarding.
- Use a 10 mm nap roller, nylon/polyester brush, pad applicator, or airless sprayer. Airless spray is recommended for experienced applicators but; utilise a .38 mm - .48 mm (.015 - .019") tip.
- If thinning is required, sparse with h2o at a rate of no more than 236 mL per 3.79 L.
- Maintain a wet edge when applying.
- Always back-brush and apply product end to end or to board lengths to preclude lap marks. Over application of stain will lead to surface failure including peeling and cracking. Avoid applying stain too heavily. Ii thin coats recommended.
- For optimum functioning, coat all half-dozen sides of the forest.
Read More than
- 1-2 hours earlier recoat. Wait 24-48 hours before low-cal pes traffic. 72 hours for total cure.
Read More
- For disposal of unused pigment products, please contact your household refuse collection service.
To consult with a Behr Certified Coatings Professional, telephone call 1-800-661-1591.
Read More than
How-To
Find step-past-step instructions in our how-to articles and videos.
BEHR PREMIUM® Wood Stain & Finish Stripper
Learn More
BEHR PREMIUM® Wood Stain & Stop Stripper
Learn More
Behr Process Corporation warrants to you, the original residential consumer purchaser, the performance of this production equally described on this label for 25 years on vertical surfaces and 10 years on horizontal surfaces, from the engagement of buy. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS Not PROPERLY APPLIED TO A PROPERLY PREPARED SURFACE OR CARED FOR IN Accordance WITH THE LABEL DIRECTIONS. Colour fading and slight natural greying of the woods may occur during the warranty menses, peculiarly in areas exposed to heavy foot traffic or excessive weather. This warranty is not transferable. If this product is institute not to perform as specified on the label during the warranty period, Behr Process Corporation volition, at its option and upon presentation of proof-of-purchase (the original receipt), either replenish an equivalent amount of new product or refund the original buy price of this production to yous. The clause of limitation of liability which follows is extraneous in Québec.This warranty excludes (1) labour and costs of labour for the application or removal of any production, and (2) any incidental or consequential amercement, whether based on breach of limited or implied warranty, negligence, strict liability or whatsoever other legal theory.The to a higher place provisions are not intended to operate where prohibited past constabulary. This limited warranty is the only warranty provided past Behr Process Corporation unless extended by a provincial consumer statute. To obtain warranty service, phone call 1-800-854-0133 ext. two, or contact Behr Procedure Corporation at 2750 Centre Avenue N.Eastward., Calgary, AB T2A2L3. Behr Process Corporation reserves the correct to inspect any and all application of the production prior to processing your claim made under this warranty.
Never miss out on the hottest deals and latest news from BEHR.
sheldonstaend1940.blogspot.com
Source: https://www.behr.ca/consumer/products/wood-stains-finishes-cleaners-and-strippers/solid-color-wood-stains/behr-premium-solid-color-waterproofing-stain-and-sealer
0 Response to "Review Comparing Behr Solid Weatherproof Deck Stain to Its Premium Product"
Post a Comment